Selection Keys - ABB PowerValue 11 RT G2 Guide Rapide

—
Operation
You can operate the UPS through
the user-friendly display
Selection
UPS start-up
To start up the UPS with mains
supply:
1. Check that all cables are securely
and correctly connected.
2. Keep the power button pressed
for longer than 1 second. The
fans will activate and the UPS will
load for a few seconds.
3. The UPS will perform a self-test
and the LCD will show the default
UPS status screen
Note: Bypass mode is enabled by
default and can be configured
O P E R AT I O N
LCD
keys
(see chapter 4 of the user manual
for a full list of possible operations).
VAC
H %
z
VDC
H
M
through the user's settings (for
more information, see table 6 of the
user manual).
To start up the UPS without mains
supply (cold start):
4. Check that all cables are securely
and correctly connected.
5. Keep the power button pressed
for longer than 1 second. The UPS
will power on, the fans will
activate and the LCD will turn on.
The UPS will perform a self-test
and show the default UPS status
screen.
19