How To Operate - Nostalgia Electrics Vintage Collection CCP200 Instructions Et Recettes

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

HOW TO OPERATE

Before first use, clean the inside of the unit by wiping with a moist, non-abrasive
sponge, towel or cloth and then wipe with a non-abrasive dry towel. Wipe down the
inside of the Kettle and be sure it is properly placed in the brackets before starting.
1.
First, find a flat surface near an electrical outlet before starting. Make sure your cord
is away from any water source. It is acceptable to use an extension cord if needed.
2.
Gather your popcorn making supplies: popcorn, seasonings, bowls or bags for holding
the popcorn, cooking oil, Kernel Measuring Cup (B) and Oil Measuring Spoon (D).
(Kernel Measuring Cup and Oil Measuring Spoon are included with your unit).
3.
Plug in the appliance while switch is flipped to OFF position.
4.
Make sure Kettle is properly secured in support brackets.
5.
Make sure Kettle motor is plugged in.
6.
Turn appliance ON by flipping the switch on the top of the machine (see illustration above
for location of switches). Allow the appliance to run 3-5 minutes to heat up Kettle.
7.
Turn unit OFF.
8.
Use the Oil Measuring Spoon supplied with your OLD FASHIONED MOVIE TIME
POPCORN CART to add 1 tablespoon of your favorite popcorn cooking oil to the
Kettle. For best popping results, it is suggested to use light vegetable oil.
9.
Add popcorn kernels to the Kettle using supplied Kernel Measuring Cup (B).
10. Turn the unit ON and close the door. In no time at all, you will hear the popping begin. Fresh,
hot popcorn will begin to burst out of the flip lids on the Kettle - just like at the theater!
10

Publicité

Table des Matières
loading

Table des Matières