Assembly of Wheels
1.
Insert Axle Rod (F) into Base Support (I).
2.
Put on #5 Flat Washer. Slide Wheel (G) into Axle Rod (F) and
add a second #5 Flat Washer.
3.
Use the end of Wrench (H2) with small notch to hold the Axle Rod notch in place.
While holding Axle Rod (F) in place, tighten the #6 Nut Cap with Wrench (H1).
4.
Add #5 Flat Washer, second Wheel (G), another #5 Flat Washer, and #6 Nut Cap
to the other side of the Axle Rod (F), following the directions above.
(#5)
Flat
Washer
(#6)
Nut
Cap
(F)
Axle
Rod
(I)
(G)
Base
Wheel
Support
8