Overload Indication - Wavetek Meterman 220 Manuel D'utilisation

E • Funda Protectora
La funda con pie integrado protege el medidor en caso de caídas accidentales. Las
puntas de prueba pueden fijarse a la funda.
F • Gaine de Protection
La gaine protège l'appareil contre des chutes accidentelles et des chocs. Les sondes
des cordons peuvent être attachées à la gaine.
while range is locked) is also indicated by "I.OL". Select the next higher range
until a value is displayed, or return to autoranging. If overload still exists in the
highest range, remove test leads from the measurement setup as input is beyond
the range of the meter.
Note: The overload indication (no sound) is normal in the Ohms, continuity and
logic ranges. It appears in Ohms and continuity when the leads are not connected
to anything or when the measured value is higher than the selected resistance
range. It is on all the time in Logic.
current could result). All current ranges are protected by fast acting fuses.
D • Überlastanzeige
Eingangs-Überlast (höchster Bereich in automatischer Bereichswahl - Fig. 1):
"I.OL" Anzeige und Dauerton. Messung unterbrechen da der Meßwert die
Eingangsgrenze überschreitet.
Bereichs-Überlast (Der Eingang überschreitet den betreffenden Bereich bei

OVERLOAD INDICATION

Input Overload (highest range in autoranging) is
indicated by "I.OL" and a continuous tone. Remove
test leads from the measurement setup as the input is
beyond the range of the meter.
Display Overload (input exceeds the selected range
Function Error: The meter dispays a function error
code "FErr" when a test lead is placed in the mA or
10A input jack and the selector switch is not set to the
correct current position. (If the DMM is connected to
a voltage source with leads set for current, very high
Battery Low: When the battery low indicator is
displayed the battery has less than 50 hours operation
and the accuracy of the meter can no longer be
guaranteed.
- 7 -