Vaporesso GEN FIT 40 Consignes D'utilisation page 3

FIGURE 2
USER INSTRUCATIONS
1. Install the Tank
Install the tank to the battery by screwing the 510 thread.
2. Replace the Coil (Refer to FIGURE 1)
- Unscrew the thread base from the tank;
- Pull out the used coil in the tank;
- Install a new coil to the tank;
- Reattach the thread base into place.
3. Fill the E-liquid (Refer to FIGURE 2)
- Push the top cap according to the arrow direction;
- Please wait 5 minutes for the e-liquid to soak into the coil
completely.
on the bottom of the tank.
5. System Operating
(1) Power on/off: press the power
button 5 times in 2s.
(2) Lock/unlock the Buttons:
press the power button 3 times
continuously to lock or unlock the "+"
button and "-" button.
(3) Start Vaping: press and hold the power button to start
vaping. For your safety, please do not vape for more than 10
seconds at a time.
(4) Adjust the Power: press the "+" button or "-"
button to adjust the power.
(5) Flip the Screen: press the power button and "+" button
(6) System Setting: press the "+" button and "-" button
simultaneously to enter the system setting interface, which
includes VV, VW, SMART VW, and DEFAULT.
SMART VW: select "SMART VW" and press the
power button to enter ON/OFF setting.
VW: select "VW" and press the power button to
enter VW mode.
VV: select "VV"and press the power button to
enter VV mode.
DEFAULT: select "DEFAULT", "YES" and press
the power button to restore the factory setting.