Publicité
Installing icemaker tie-downs
Required for some icemaker applications only. If this fitting is
included with your bin, proceed as follows:
1. Locate icemaker back flush with bin back.
2. Using center of vertical slot as template, drill through
icemaker wall with a 15/64 drill.
3. Fasten straps to icemaker and bin (bin holes are predrilled)
with #14 x 1/2 sheet metal screws and washers provided.
Removing lower door assembly
(only if required for access through narrow doors)
1. With lower access door closed, remove Phillips head screw
and washer from hinge area on each side.
2. Insert screwdriver between door and hinge bracket on one
side of door and gently push against bracket to provide
room for door stud to clear bracket.
3. Remove access door.
4. Pull up on SmartGATE to remove.
5. Remove three (3) or four (4) screws along top of door
assembly.
6. Pull forward on assembly and remove.
Reinstalling door assembly
1. Reinstall lower door assembly in bin opening.
2. Reinstall three (3) screws in hood at top of door assembly.
3. Reinstall SmartGATE in side panel tracks, making sure that
locking arm is pointing up, and push down to seat.
4. With door closed, insert one door stud through hinge
bracket.
Note: For proper operation the access door must be
reinstalled in the closed position.
5. On other side, insert screwdriver between door and hinge
bracket and gently push against bracket to provide room for
door stud to clear bracket.
6. Reinstall washers and screws in lift door and tighten.
7. Check door to ensure proper operation.
5
icemaker back
15/64" hole
drilled through
icemaker wall
tie-down strap
bin back
access door
SmartGATE
lower door assembly
Publicité
