Publicité
Welcome to Follett
Follett ice storage bins enjoy a well-deserved reputation for excellent performance, long-term reliability and outstanding
after-the-sale support. To ensure that this bin delivers that same degree of service, we ask that you take a moment to
review this instruction before beginning the installation of the bin. Should you have any questions or require technical
help at any point, please call our technical service group at (800) 523-9361 or (610) 252-7301.
Before you begin
After uncrating and removing all packing material, inspect the equipment for concealed shipping damage. If damage
is found, notify the shipper immediately and contact Follett Corporation so that we can help in the filing of a claim,
if necessary.
!
Important cautions
Avoid excessive tightening force when connecting to the bin drain fitting.
Do not apply excessive heat if any sweating of fittings is necessary. Heat conduction through
metal may melt threads in plastic drain fitting.
Installation
All single section upright bins
Please read the following instructions carefully before proceeding with installation.
Note: Follett recommends the installation of a floor drain with grate with all ice storage bins.
1. Remove all packing material from bin.
2. Remove set of four legs (model 1850-96 has six) and any other accessories packed inside bin.
3. Lay bin on its back being careful to protect finish, and remove bolts holding skid to bin.
4. Screw legs into tapped holes in bin bottom and tighten to seat legs well against bottom. (On model 1850-96 install two
extra legs in holes drilled at front and rear center of bin.)
5. Remove protective paper from stainless steel surfaces.
6. Set bin upright and move it to permanent location.
7. Adjust "foot" at bottom of each leg to level bin in both directions.
8. For model SG2250-72 only, use supplied plugs to close bolt holes in bin back to prevent contamination of insulation.
9. Mount icemaker(s) on bin in accordance with icemaker manufacturer's instructions.
10. Remove all tape and temporary fastenings from door assemblies and outside of bin.
11. Connect drain line to 1" FPT female fitting located in bottom of bin.
12. Make final connections to icemaker.
Two-section upright bins
Please read the following instructions carefully before proceeding with installation.
Note: Follett recommends the installation of a floor drain with grate with all ice storage bins.
1. Remove all packing material from both sections of bin.
2. Remove set of four legs and any other accessories packed inside lower section of bin.
3. Screw legs into tapped holes in lower section and tighten to seat legs well against bottom.
4. Set lower section upright and remove bolts holding skid to back of bin.
5. To prevent contamination of insulation, use supplied plugs to close bolt holes in bin back.
6. Remove protective paper from stainless steel surfaces and move bin to permanent location.
7. Adjust "foot" at bottom of each leg to level bin in both directions.
8. Run a 1/8" (3mm) bead of silastic sealant over center of each gasket on lower section, including over brackets
(see figures on page 4).
(packed in one crate)
(models SG3200-72, SG3900-72, and SG4600-72 only)
3
Publicité
