Waeco MagicTouch MT350 Instructions De Montage Et De Service page 44

MT-350.book Seite 44 Montag, 20. November 2006 4:28 16
Safety and installation instructions
Warning
e
To prevent short circuits, always disconnect the negative terminal of the
electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should also be
disconnected.
Warning
e
Inadequate cable connections can cause short circuits, resulting in:
– Cable fires
– The airbag being triggered
– Damage to electronic control equipment
– Electrical malfunctions (indicators, brake light, horn, ignition, lights)
Please therefore observe the following instructions:
When working on the following cables, only use the cable connectors supplied:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– L (indicator lights, left)
– R (indicator lights, right)
Do not use terminal strips.
Use a crimping tool (fig. 1 10, page 3) to connect the cables.
For permanent connections, you can solder the cable ends together and then
insulate them.
Screw the cable for connections to cable 31 (earth)
– Screw on the cable using a cable terminal and serrated washer to one of the
vehicle's earth bolts
– Screw the cable to the bodywork using a cable terminal and a self-tapping
screw
Make sure there is a good earth connection.
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
The following data must be set again, depending on the vehicle equipment op-
tions:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating
manual.
44
MagicTouch MT350