Connecting The Appliance To The Power Supply - AEG MW17EG10 Notice D'utilisation

9.2 Safe use of the appliance
If fitting the microwave in position B or C:
• The cupboard must be a minimum of
500 mm (E) above the worktop and must
not be installed directly above a hob.
• This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
• Sufficient space between hob and
IMPORTANT! Ensure the bottom
of the oven is 85 cm or more
above the floor. It is important to
ensure that the installation of this
product conforms to the
9.3 Connecting the appliance to the power supply
(A)
microwave should be allowed to
prevent overheating of microwave
oven, surrounding cupboard and
accessories.
• Do not operate the hob without pans
when the microwave oven is
operating.
• Care should be taken when
attending to the microwave oven
while the hob is on.
instructions in this operation
manual and the conventional oven
manufacturer's installation
instructions.
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or
it should be possible to isolate the oven
from the supply by incorporating a
switch in the fixed wiring in accordance
with the wiring rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the
cupboard, see (A).
• Connect the appliance to a single
phase 230 V/50 Hz alternating current
via a correctly installed earth socket.
The socket must be fused with a 16 A
fuse.
• The power supply cord may only be
replaced by an electrician.
• Before installing, tie a piece of string
to the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into
the high-sided cupboard, DO NOT
crush the power supply cord.
• Do not immerse the power supply
cord or plug in water or any other
liquid.
ENGLISH 135