Controls: Filter Change Indicator (Carbon Filters); Set Mode - WindCrest WST300SBG Guide D'utilisation, D'entretien Et D'installation

CONTROLS: FILTER CHANGE INDICATOR (Carbon Filters)

FIlter Change Reminder (Carbon, if fitted):
When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of Carbon FIlters to purify
exhaust and fumes from cooking, and re-circulates the air within the home. These Carbon Filters are required to be
replaced after every 120 hours of use. The Filter Change Reminder function in the microprocessor needs to be switched
on. The microprocessor in the controls when set, will elapsed and count usage time and indicate by a flashing
carbon filter replacement is needed every 120 hrs.
Setting the Filter Change Reminder:
When Off, hold for approx. 5 seconds.
The display will change from
(purifying mode/carbon filters used) this indicates that the
elapse timer function is switched on and Carbon Filters
are used.
Filter Replace Indicator:
When the diplay starts flashing, the Carbon Filters
requires replacement after 120 hours of use.
Re-setting Function:
Once filters are replaced, with hood off, press and hold
the display will appear; hold for approximately 5 seconds
until on display disappears
Reminder is now re-set and a new 120 hours elapse cycle
is initiated.
(exhaust mode) to ,
,
. The Filter Change
14

Set Mode

hold 5 secs. display from <--> to <C>
Change Filters
display <C> flashes
To Reset
display from <C> to < >
hold 5 secs.
when