Mounting The Duct Cover And The Glass Canopy; Cable Lock - WindCrest WST300SBG Guide D'utilisation, D'entretien Et D'installation

Electrical Supply:
This appliance requires a 120V 60Hz electrical supply,
and connected to an individual, properly grounded
branch circuit, protected by a 15 or 20 ampere circuit
breaker or time delay fuse. Wiring must be 2 wire w/
ground. Please also refer Electrical Diagram labeled
on product.

Cable Lock:

A cable locking connector (not supplied) might also
required by local codes. Check with local requirements
and codes, purchase and install appropriate
connector if necessary).
Cable Lock
9. Fasten E-Z Anchors to wall (see below) as marked.
10. Fasten screws provided onto EZ Anchors, do not
fasten screws all the way.
11. Fasten right and left hanging brackets onto hood;
hang hood on wall and hand tighten (fig. A).
15"
12. Inside the blower unit remove shipping block from
blower assembly prior to use of appliance.
13. Connect duct work and electrical to the blower unit.

Mounting the Duct Cover and the Glass Canopy

1. Center and attach duct cover support bracket on
wall below ceiling or soffit with anchors and screws.
2. Insert the duct covers and slide down the top duct
cover.
3. Insert and slide the glass canopy over the glass
brackets.
4. Slide up the top duct cover and fix it onto bracket
with 2 screws.
Note:
Whenever possible, the hood should be secured to
wall studs. If a stud or wood surface is present, fasten
anchors with screws directly into stud or plywood. For
all other wall types (concrete, brick, tiles, etc.) use
appropriate anchors for mounting.
11
www.windcrestcnp.com