Touch Controls & Features - WindCrest WST300SBG Guide D'utilisation, D'entretien Et D'installation

TOUCH CONTROLS & FEATURES
1. Blower On/Off
By pressing , the blower is switched On and Off. When switched On, the blower starts up on speed level 2.
2.
Speed Selection
The 3 speed levels are selected by pressing
level selected.
3. Delay Off
This is used for programmed shut down of blower and lights 15 minutes after the function is activated.
Press once, a dot flashes in the lower right hand side of display
The hood will completely shut down in 15 minutes.
4. Lights On/Off
Switch lights On and Off by pressing key
5. Advance Display Functions
Filters Clean Reminder (Metal):
After every 30 hours of use, the display will star flashing an
and possible clogs.
The standard Metal Filters fitted are required to be cleaned frequently and as recommended in order to maintain
blower efficiency. If improperly maintained, residue from cooking will sift through filters and cause damage to hood
blowers and other sensitive components; and possibly clog duct work creates fire hazard.
Filters Change Reminder (Carbon, if fittted):
When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of Carbon Filters to
purify exhaust and fumes from cooking, and re-circulates the air within the home. These Carbon Filters are required
to be replaced after every 120 hours of use. The Filter Change Reminder function in the microprocessor needs to be
switched on. The microprocessor in the controls when set, will elapsed and count usage time and indicate when
carbon filter replacement is needed every 120 hrs.
1
Blower On/Off
5
Display
2
Adjust 3 Speed Levels
once.
(Speed level, Delay Off Indicator, Filter Clean/Change)
4
Lights On/Off
3
15 Min Delay Off
to decrease and to increase speed level. The display indicates
reminding you to clean the metal filters from residue
13
www.windcrestcnp.com
indicating the function is on.