Additional Function Ql320 Hv - OBL QL320 Série Mode D'emploi

Manual mode:
In the manual mode the self levelling is deactivated on both axis. The X- and
Y-direction can be inclined. The tilt control in this mode is always deactivated.
To leave the manual mode press the ON-Off button. The laser turns back to
self levelling mode.
To turn the laser off, press the On-Off button once again.

Additional function QL320 HV:

The QL320HV can be used in vertical mode. Therefore place the instrument
vertical on the ground. The Z-direction will be self levelled.
With the arrow keys the plumb beam can be used to align the vertical laser
plane.
The tilt control can be turned off like in the horizontal mode.
28
Manual mode, to activate press the mode key once again
(lower LED flashes)
Self levelling turned off, inclining laser plane with the up
and down arrow keys possible.
Indicates the direction that get inclined with the arrow
keys. To toggle between X and Y press mode button.
Arrow keys to move the laser plane up or downwards in
X- or Y- direction.
The movement starts slowly, then increases speed.
The direction of the arrows corresponds direction marks
on the housing.