Makita BST220 Manuel D'instructions page 4

ENGLISH
1. Red part
2. Button
3. Battery cartridge
4. Trigger
5. Safety lever
6. Sub magazine
SPECIFICATIONS
Applicable staples length
Staple magazine capacity
Overall length
Rated voltage
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
Intended use
The tool is intended for pressing staples into construction
materials such as timbers.
ADDITIONAL SAFETY RULES
FOR TOOL
1. Always wear safety goggles or safety glasses with
side shield, and a full face shield when needed.
2. Do not point the ejection port at anyone in the
vicinity (especially his face). Keep hands and feet
away from the ejection port area.
3. Always remove the battery cartridge before
loading the staples, adjustment, inspection,
maintenance or after operation is over.
4. Make sure no one is nearby before operation.
Never attempt to drive staples from both the inside
and outside of wall at the same time. Staples may
rip through and/or fly off, presenting a grave
danger.
5. Watch your footing and maintain your balance
with the tool. Make sure there is no one below
when working in high locations.
6. Check walls, ceilings, floors, roofing and the like
carefully to avoid possible electrical shock, gas
leakage, explosions, etc. caused by stapling into
live wires, conduits or gas pipes.
7. Use only staples specified in this manual. The use
of any other staples may cause malfunction of the
tool.
8. Do not tamper with the tool or attempt to use it for
other than driving staples.
4
Explanation of general view
7. Locking lever
8. Staples
9. Main magazine
10. Groove
11. Hook
12. Screw
Model
Staple width
Net weight
BST220
10.5 mm
10 mm - 22 mm
84 pcs
247 mm
2.2 kg
D.C. 14.4 V
9. Do not operate the tool without staples. It shortens
END004-2
the service life of the tool.
10. Stop driving operations immediately if you notice
something wrong or out of the ordinary with the
tool.
11. Never staple into any materials which may allow
the staple to puncture and fly through as a
ENE054-1
projectile.
12. Never actuate the switch trigger and safety lever
at the same time until you are prepared to staple
workpieces. Allow the workpiece to depress the
safety lever. Never defeat its purpose by securing
the safety lever back or by depressing it by hand.
ENB069-1
13. Never tamper with the safety lever. Check the
safety lever frequently for proper operations.
SAVE THESE INSTRUCTIONS.
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter,
stop operating immediately. It may result in a risk
of overheating, possible burns and even an
explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any
conductive material.
13. Nut
14. Front
15. Workpiece
16. Rear
17. Sight window
BST221
10.5 mm
10 mm - 22 mm
84 pcs
251 mm
2.3 kg
D.C. 18 V
ENC007-2