Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating modes
Run mode
Normal operating mode
After power on the unit is in the Run mode. It carries out its monito-
ring function and generates output signals according to the set para-
meters.
The display indicates the current distance, the yellow LEDs signal the
switching status of the outputs.
Display mode
Indication of the parameters and the set parameter values
After a short press of the "Mode/Enter" button the unit goes to the
Display mode. Internally it remains in the operating mode. Irrespective
of this the set parameter values can be read:
• Press the "Mode/Enter" button briefly to scroll the parameters.
• Press the "Set" button briefly to indicate the corresponding para-
meter value for 15 s. After another 15 s the unit returns to the Run
mode.
Programming mode
Setting of the parameter values
The unit goes to the programming mode when a parameter has been
selected and the "Set" button is then pressed for over 5 s (the indica-
ted parameter value flashes and is then incremented continuously).
Internally the unit remains in the operating mode. It continues its
monitoring function with the existing parameters until the change has
been terminated.
You can change the parameter value by pressing the "Set" button and
confirm it by pressing the "Mode/Enter" button. The unit returns to
the Run mode if no button is pressed for over 15 s.
All manuals and user guides at all-guides.com
19
Publicité
Table des Matières
