Latchways PRD Mode D'emploi page 8

EN
Pre-use checks
Descent device/line (continued)
Figure 6
Figure 7
Figure 8
Figure 9
8
• Inspect descent line for any 'slack' between the drum and rack
(Figure 6). If the line is slack the Latchways PRD descender
device shall be removed from service and advise sought from
Latchways or authorised agent.
• Check the legibility of the product markings.
• Inspect the release pin for signs of damage, distortion, corrosion
or cracking. Ensure that it is engaged. Ensure that the red release
cord is positioned under the release pin and that the load-line
webbing is looped around the release pin (Figure 7).
• Ensure that the green release pin clip is present and undamaged—
check for signs of damage, distortion or cracking (Figure 7).
• Ensure that the release cord guide is undamaged (Figure 8).
• Inspect the descent line, load-line and release cord for signs of cuts,
abrasion, fraying, tears, mould, discolouration, chemical attack or
excessive build-up of dirt. Check the stitching for signs of loosening,
pulling or cut thread. Excessive build-up of dirt may prevent the
descent line from pulling through the device. If damage is apparent
the Latchways PRD descender device shall be removed from service
and advise sought from Latchways or authorised agent.
• After inspection close the zip on the backpack fully.
• Unzip the back panel of the backpack and inspect the harness
connector for signs of damage, distortion, corrosion or cracking.
Ensure that the fastening bolt is secure (Figure 9). If damage is
apparent or the bolt insecure the Latchways PRD descender device
shall be removed from service and advise sought from Latchways
or authorised agent.
• Inspect all system components and subsystems according to
Latchways' instructions.