Lagrange Minimixeur Notice page 39

Do not embed the unit.
*
These units are not intended for operation by
*
exterior timers or by remote-control systems.
Never cover the unit with a cloth when it is
*
operating.
Remove the cutting unit before cleaning.
*
Always check to be sure that the blender is
*
perfectly clean before using it. For instructions
for the cleaning of surfaces in contact with
food, please refer to the "Cleaning and
Upkeep" section.
Always clean the parts used for preparation
*
thoroughly after each use.
The blades are very sharp. Handle them
*
carefully, particularly when emptying the
bowl and during cleaning.
WARNING! Risk of injury in the event of
*
inappropriate use of this unit.
Never put hot oil or fat into your blender.
*
Follow the instructions in the preparation
guide.
Never put ingredients into the bowl of the
*
blender when the unit is in operation.
The capacity of the ingredients must not
*
exceed the maximum graduation that
appears on the bowl of the blender. For
the ingredients, refer to the table of the
"Preparation Guide" section and do not
exceed the maximum quantities and times
indicated.
The blender must be activated by pulses of
*
15 seconds (maximum) and must not operate
for more than 60 seconds ( 4 consecutive
pulses). After continuous functioning for
60 seconds ( 4 consecutive pulses of 15
seconds), let the blender cool down for about
2 minutes before using it again.
Do not use the blender continuously for long
*
periods of time. The motor can overheat.
If the surface of the unit is very hot, it may
take a certain time for it to cool down. The
unit can be used again once it has returned
to room temperature.
Avoid all contact with moving parts.
*
Keep fingers, hair, clothes and utensils away
*
from the moving parts.
39
E N G