Philips sonicare ProtectiveClean 4500 Serie Mode D'emploi page 17

Masquer les pouces Voir aussi pour sonicare ProtectiveClean 4500 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Battery status and charging
2 Press and hold the power on/off button
while the handle remains on the charger.
3 Keep the power on/off button pressed until
you hear a series of three short beeps (after
6-7 seconds).
4 Release the power on/off button.
- Triple tone of low-med-high means the
pressure sensor feature has been
activated. The brush head replacement
light and battery light will also blink
green 2 times in unison to confirm
activation.
- Triple tone of high-med-low means the
pressure sensor feature has been
deactivated. The brush head
replacement light and battery light will
also blink amber 1 time in unison to
confirm deactivation.
If you continue holding the power on/off
button after the three short beeps, the
activate/deactivate sequence repeats.
1 Put the plug of the charger in an electrical
outlet.
2 Place the handle on the charger.
- The charger will emit 2 short beeps to
confirm that the handle is placed
properly.
17
English

Publicité

Table des Matières
loading

Table des Matières