Black & Decker GK430 Mode D'emploi page 5

•
Locate the cable and cable protector into the
body correctly (see below, figure a). Then fit the
cable clamp over the outer sheath of the cable
and screw down until the screws are fully home.
Failure to do this may result in the cover not
fitting correctly to the connector body.
•
Before replacing the cover of the 'female'
connector make sure that the cable clamp is
holding the outer sheath of the cable firmly with
screws fully home and that the two leads are
correctly fixed at the terminal screws and are not
taut (see below, figure a).
•
Place the cover onto the body assembly
ensuring that it seats flat, then retighten the fixing
screw into the nut until the cover is securely held
(see below, figure c).
•
Finally check that the cable protector is secure
and that there are no gaps between the cover
and the connector body.
terminal screws
clamping washers
connector body
6mm
cable
clamp
cable
protector
Fitting the mains plug
•
The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for 'Live' (L) and
blue is for 'Neutral' (N).
•
The recommended fuse to use with this product
is 13 amps. Please ensure that the plug being
fitted is equipped with a fuse of the correct rating.
Note: Fuses do not give personal protection
against electric shock.
•
Before replacing the top cover of the mains plug
ensure that the cable restraint is holding the
outer sheath on the cable firmly and that the two
leads are correctly fixed at the terminal screws.
•
Do not wire an extension cable directly into your
machine. Rather than attempting this yourself,
you should take your machine to your nearest
Black & Decker Service Station.
All manuals and user guides at all-guides.com
Fit a rubber
covered plug
Connect blue
to N (neutral)
Make sure that the
outer sheath of the
cable is held firmly by
the clamp
Additional electrical safety
Increased safety can be obtained by having a
fixing screw
qualified electrician install a high sensitivity circuit
breaker in the house wiring. If you do not have such
a circuit breaker installed, or you do not wish to have
one installed, then we strongly recommend that the
electrical power to the machine be supplied through
a 30mA high sensitivity residual current device (RCD).
The RCD is designed to provide a high degree of
personal protection against harmful electric current
should fault conditions occur.
WARNING! The use of an RCD or other circuit
breaker unit does not release the operator of the
machine from the safety instructions and safe
cover
working practices given in this manual.
Description (Fig. B)
B
ENGLISH
E
L
N
1. Saw chain
2. Guide bar
3. Side panel
4. Sliding nut
5. Tensioning screw
6. Sprocket wheel
7. Sprocket nose
8. Peg
9. Oil level indicator
10. Oil filler cap
11. Side panel nut
12. Reset button
13. Chainbrake bar
14. Lock off button
15. Trigger
Fit a 13 amp fuse
Connect brown
to L (live)
240 volts AC only.
Never use a light
socket
5