Checking Motor Liquid; Assembling The Motor And Pump; Preparation - F.B. SUBMERSIBLE MOTORS 6 Manuel De Montage Et D'utilisation

5.2 Checking the motor liquid
Top the motor up with clean fresh water
5.3 Assembling motor and pump
________________________________________________________________________________________
Damages to the motor caused by insufficient filling.
→ Top the motor up with enough liquid (see figure) and as indicated on the sticker on the motor.
→ When filling up and draining the motor, wear protective glasses and gloves.
→ Do not use distilled water.
____________________________________________________________________
Note
This assembly and user manual describes actions that refer only to the motor. In all cases it is also
necessary to read and follow the instructions given in the manual of the unit manufacturer.

Preparation

Before assembly, turn the drive shaft by hand: once it has gone beyond the point of static
friction it will turn freely.
Rotate with the hand the shaft of the pump
Surfaces of the pieces to connect are free from dust and dirt.
Coupling joint fixed to the pump shaft, sliding on the drive shaft.
21
EN