Table des Matières
Publicité
_IA_MT100.book Seite 22 Freitag, 28. Mai 2010 9:04 21
Instructions before installation
6
Instructions before installation
Supplementary to fig. 3
NOTE
I
If you do not have sufficient technical knowledge for installing and connect-
ing components in vehicles, you should have a specialist install the radio re-
mote control in your vehicle.
Your vehicle should meet the following requirements to be able to open and close it
with MagicTouch:
12 V operating voltage
Central locking system
6.1
Setting the configuration
Clarify the following before installing and programming the system:
Is the driver's door equipped with its own servo motor for locking?
If no: retrofit a servo motor (e. g. WAECO ML-11).
Some manufacturers equip their vehicles with a power-saving central locking
system. In these vehicles, there is no servo motor in the driver's door; there is
an electrical switch instead.
What type of switching function does the original central locking system
have?
NOTICE!
A
Only connect MagicTouch using the control cables for the central locking
and not using other cables.
Connection to other cables than the control cables or using an incorrect cir-
cuit plan can lead to defects in the central locking system and the remote
control.
The system must be programmed accordingly, see chapter "Connecting MT100
to the central locking system" on page 24.
You will require the circuit diagram for the central locking system to do so. You
can obtain this from your vehicle dealership. There is corresponding informa-
tion for some vehicle in chapter "Vehicle-specific data" on page 25.
If no original circuit diagrams are available and you cannot find your vehicle in
the table in chapter "Vehicle-specific data" on page 25, you will need to deter-
mine the function of the control cables that run from the control unit for the cen-
tral locking system to the vehicle doors.
22
MagicTouch MT100
Publicité
Table des Matières
