Completing Installation - Dometic GROUP Waeco MagicTouch MT200 AU3 Instructions De Montage

_MT200_AU3.book Seite 10 Montag, 19. April 2010 7:23 19
Installing and connecting the MT200
2.3

Completing installation

➤ Reattach the strap on the negative terminal of the vehicle battery again.
➤
Test the radio remote control to see if it works correctly.
NOTE
I
Pull the plug out before disconnecting the cable bridge.
There is a cable bridge (fig. 7 1, page 4) on the plug of the cable set be-
tween pin 7 and pin 11:
Cable bridge closed (factory setting): for electric servo motors (activation
time: 0.7 s)
Cable bridge open: for pneumatic servo motors (activation time: 3 s)
➤
Fasten the control device in place using the fastening material supplied.
➤ Remount the panels and covers removed.
10
MagicTouch MT200 AU3