Installing And Connecting The Mt200; Power Supply - Dometic GROUP Waeco MagicTouch MT200 AU3 Instructions De Montage

_MT200_AU3.book Seite 8 Montag, 19. April 2010 7:23 19
Suitable for installing in the following vehicles
The following information contains vehicle-specific installation instructions
for MagicTouch MT200. Refer to the installation and operating manual for any
further information.
1 Suitable for installing in the following vehicles
The MagicTouch MT200 AU3 radio remote control (item no. 9101300027) can be
used in the following vehicle types:
Audi A4 without TWS 95 – 97
Audi A6 without TWS 94 – 97
TWS: theft warning system
2

Installing and connecting the MT200

NOTE
I
Use a red piercing connector for cables with a cross-section of max. 1 mm².
Use a blue piercing connector for cables with a cross-section of between
1.5 to 2.5 mm².
➤
Undo the strap on the negative terminal of the vehicle battery.
2.1

Power supply

Audi A4, A6
➤ Connect the following cables of the radio remote control as follows:
– Connect the red cable to the "+30" screw terminal (under the dashboard,
fig. 1 1, page 2)
– Connect the orange cable to the "75X" screw terminal (under the dashboard,
fig. 1 1, page 2)
– Connect the brown cable to an available earth point
Audi A6
➤
Disconnect the ring sleeves from the following cables of the radio remote con-
trol:
– Red cable
– Orange cable
➤
Connect the following cables of the radio remote control using piercing connec-
tors (fig. 2, page 2):
– Connect the red cable with the red cable (rt) from the ignition socket
– Connect the orange cable with the black/yellow (sw/ge) cable from the igni-
tion socket
➤
Connect the brown cable of the radio remote control to an available earth point.
8
MagicTouch MT200 AU3