Dometic GROUP Waeco MagicTouch MT200 AU3 Instructions De Montage page 9

_MT200_AU3.book Seite 9 Montag, 19. April 2010 7:23 19
MagicTouch MT200 AU3
2.2 CL and indicator activation
Audi A4
Activation of the central locking and the indicators is performed at the A pillar.
➤
Disconnect the yellow/blue (ge/bl) or green/blue (gn/bl) original cable (fig. 3 1,
page 2) of pin 5 of the brown, 10-pin plug.
➤
Connect the following cables of the radio remote control as described (fig. 3 1,
page 2):
– Connect the grey/red cable to the yellow/blue (ge/bl) or green/blue (gn/bl)
original cable which runs from the central locking pump
– Connect the yellow/blue cable to the yellow/blue (ge/bl) or green/blue (gn/bl)
original cable which runs from the vehicle door
➤
Connect the following cables of the radio remote control using piercing connec-
tors (fig. 3, page 2):
– Connect the black/green cable to the black/green cable (sw/gn) from pin 10
of the brown, 10-pin plug which is located on the A pillar
– Connect the black/white cable to the black/white cable (sw/ws) from pin 9 of
the brown, 10-pin plug which is located on the A pillar
Audi A6
➤
Disconnect the yellow/blue (ge/bl) or green/blue (gn/bl) original cable which
runs from the A pillar.
➤
Connect the following cables of the radio remote control as described (fig. 5 1,
page 3):
– Connect the grey/red cable to the yellow/blue (ge/bl) or green/blue (gn/bl)
original cable which runs from the central locking pump
– Connect the yellow/blue cable to the yellow/blue (ge/bl) or green/blue (gn/bl)
original cable which runs from the vehicle door
➤
Connect the following cables of the radio remote control using piercing connec-
tors (fig. 4, page 3):
– Connect the black/green cable to the black/green cable (sw/gn) of the blue,
3-pin plug which is located above the fuse box
– Connect the black/white cable to the black/white cable (sw/ws) of the blue,
3-pin plug which is located above the fuse box
Installing and connecting the MT200
9