Table des Matières
Publicité
_IA_MT100.book Seite 33 Freitag, 28. Mai 2010 9:04 21
MagicTouch MT100
9
Operating MagicTouch
9.1
Using the remote control
See fig. d
Observe the following instructions when you use MagicTouch:
To ensure the remote control functions properly, a disturbance-free connection
between the hand-held transmitter and the control unit is required.
Depending on where the control unit is installed, and the transmission power of
nearby sources of interference, the range is up to 20 m.
Each time the hand-held transmitter is used, it sends a new code (rolling code).
For this reason, the control unit might not recognise the hand-held transmitter
immediately if you use the hand-held transmitter too frequently without the con-
trol unit receiving the transmission signal. In this event, press the hand-held
transmitter again another one to three times; after the third attempt at the latest,
the control unit will detect the hand-held transmitter again.
To close the central locking:
➤
Press the "Close" button on the hand-held transmitter.
✓
If the ignition is switched off, the hazard light flashes once for confirmation.
✓
If installed (accessory): The status LED starts flashing.
To open the central locking:
➤
Press the "Open" button on the hand-held transmitter.
✓
If the ignition is switched off, the hazard light flashes twice for confirmation.
✓
If installed (accessory): The status LED goes out.
9.2
Replacing the battery
See fig. e
You must replace the batteries:
when the range of the hand-held transmitter decreases distinctly, or
when the control LED flickers during transmission or
when, after opening, the hazard lights flash quickly 5 times. In this case, replace
the battery within one month.
Please observe the following instructions for batteries:
WARNING!
!
Children could swallow batteries. Keep the batteries out of reach of chil-
dren.
Only use leak-proof batteries that are suitable for electronic devices.
Operating MagicTouch
33
Publicité
Table des Matières
