Dimensions; General Installation Guidelines; Preliminary Checks - CAME XVIA Manuel D'installation

Dimensions

GENERAL INSTALLATION GUIDELINES

⚠ Only skilled, qualified staff must install this product.

Preliminary checks

⚠ Before installing the turnstile, you need to:
• if needed, set up corrugated tubing for the electrical cables to pass through;
• set up a dual-pole cut-off switch with minimum contact openings of 3 mm, and section-off the power supply;
• Set up suitable tubes and conduits for the electric cables to pass through, making sure they are protected from any mechanical damage;
• Make sure that any connections inside the container (ones that ensure continuity to the protection circuit) are fitted with additional insulation with respect to
those of other electrical parts inside.
Cable type and minimum section
Connection
Gearmotor with control board
Command and control devices
Safety devices
24 V accessories
When operating at 230 V and outdoors, use H05RN-F-type cables that are 60245 IEC 57 (IEC) compliant; whereas indoors, use H05VV-F-type cables
that are 60227 IEC 53 (IEC) compliant. For power supplies up to 48 V, you can use FROR 20-22 II-type cables that comply with EN 50267-2-1 (CEI).
To connect to the CRP, use UTP CAT5-type cables up to 1,000 m in length.
 If cable lengths differ from those specified in the table, establish the cable sections depending on the actual power draw of the connected devices and
according to the provisions of regulation CEI EN 60204-1.
For multiple, sequential loads along the same line, the dimensions on the table need to be recalculated according to the actual power draw and distances.
For connecting products that are not contemplated in this manual, see the literature accompanying said products
978
848
1176
Ø 40
266 500
42 180
cable length
< 20 m
3G x 1.5 mm²
2 x 0.5 mm²
2 x 0.5 mm²
2 x 0.5 mm²
20 < 30 m
3G x 1.5 mm²
2 x 0.5 mm²
2 x 0.5 mm²
2 x 0.5 mm²