Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FINAL OPERATIONS
Once the electrical connections and commissioning are done, fit the lateral carters. ❶ ❷ ❸
Connect the LED signal lights by using the corresponding terminals. ❹
Refit the cover and lock the locks. ❺❻
MAINTENANCE
Before doing any maintenance, cut off the power supply, to prevent any hazardous situations caused by accidentally activating the operator.
To properly maintain the AISI 304 stainless steel, refer to the stainless steel cleaning part of the 119RW48 manual (https:\docs.came.com and type inox).
Table of the mean cycles between failures (MCBF) of XVIA turnstiles, considering proper installation and maintenance as described in this manual:
Model
001PSXV02
001PSXV3
Periodic maintenance
• Every 1,000,000 cycles and, anyhow, every six months:
•
With the mains power cut off, check for smooth sliding and
gearmotor reversibility;
•
check proper fastening of the nuts;
•
clean the inside of the operator from any dust created during
operation;
•
check tightness of bolts on tripod head;
•
check efficiency of the fall-away arm;
Operating limits
Maximum number of daily cycles: continuous service
Maximum number of cycles per minute: 30 (1 cycle every 2 seconds)
•
check that all electrical and wiring connections are sound;
•
wipe clean the LED signal lights using a cloth moistened only with
water;
•
check that the tripod's rotation is properly calibrated (you may have to
reprogram the corresponding functions)
MCBF
3,000,000
Publicité
Table des Matières
