Using The Cold Water Dispenser(Rfg238 Model) - Samsung RFG237 Serie Mode D'emploi

Operating your French Door Refrigerator
(RFG238 MODEL)
Controlling the fridge temperature
The fridge temperature can be set between 7 ℃ and 1 ℃ to suit your particular needs. Press the fridge button
repeatedly until the desired temperature is shown in the temperature display. The temperature will move -18 ℃
degrees each press(3 ℃ → 2 ℃ → 1 ℃ → 7 ℃ → 6 ℃ → 5 ℃ → 4 ℃ → 3 ℃ ). The temperature control process for the
fridge works just like the freezer process. Press the fridge button to set your desired temperature. After a few
seconds, the fridge will begin adjusting towards the newly set temperature. This will be refl ected in the digital
display.
Using the Power Cool
For a quick Fridge cool down, use the Power Cool function. Press
and hold the Fridge / Power Cool (3 sec) button for 3 seconds.
Then, the power cool indicator will light and activate the power cool
mode independent of fridge set temperature. If you select Power
Cool, the inside temperature of the fridge will decrease for about two
and a half hours or until -4 ℃ is reached. Press and hold the button for
3 seconds again to cancel the Power Cool mode. Then, the indicator
will go out and the Refrigerator will return to the set temperature
again.
- The temperature of the Freezer, fridge or Pantry Room may rise
when you open the doors too frequently, or if a large amount of
warm or hot food is placed inside.
- This may cause the digital display to blink. Once the Freezer and
fridge temperature return to their normal set temperatures, the
blinking will stop.
- If the blinking continues, you may need to "reset" the Refrigerator.
Try unplugging the appliance, wait for around 10 minutes and then
plug the power cord back in.
- If there is an communication error between the Display and Main Controller, the Pantry Display light may blink.
Once the normal set temperatures are reached, the blinking will stop.
If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center.
USING THE COLD WATER DISPENSER
Press the Ice type or Water button to select the type of you want
Using the ice Dispenser
Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass.
Make sure the glass is in line with the dispenser to prevent the ice from bouncing out.
Please wait 2 seconds before removing the glass under the dispenser to prevent
spills. If the Refrigerator door opens, the Dispenser does not work.
CAUTION
When Cubed Ice is selected after using the Crushed Ice mode, a small amount of
residual crushed ice might be produced.
CAUTION
DA68-01827C-17.indb 29 DA68-01827C-17.indb 29
ntroller the Pantry Display light may blink
No ICE
Select this if you want
to turn ice maker off.
Operating _29
PUSH
2014. 5. 14. 2014. 5. 14. 10:02 10:02