Installation - AUDIOropa PRO IR-400 Mode D'emploi

Installation

Figure F)
1. An AC/DC power adaptor is supplied with your PRO IR-400. First insert the output jack of
the adaptor into the „DC Power" socket of the transmitter.
2. Connect the "AUDIO IN" ports of the transmitter with the Audio-Out ports of your chosen
audio source.
3. Plug the power supply into a mains outlet.
4. In case you would like to transmit speech, it is possible to connect 600 Ohm dynamic
microphones (or high impedance condenser microphones) to the "MIC-IN"- ports.
The incoming microphone signal can be mixed with the main audio signal.
5. The transmitter can be mounted on walls, according apertures are located on the
rear side (Figure A, Pos. 13) of the device. It can also be mounted upon a tripod or
other bracket.
Power supply
Connection to Audio-Out of audio sources
Optionally: Microphones
Mains outlet
audio sources,
as required
English 17