Playing Photo Contents; Using The Tools Menu; Appendix; Troubleshooting - Samsung BD-E5400 Mode D'emploi

playlist
1.
To move to the Music List, press the 5
or RETURN button.
The Music List screen appears.
Music
TRACK 001
TRACK 001
TRACK 001
02:38
02:38
TRACK 001 TRACK 001
02:38 02:38
TRACK 001 TRACK 001
02:38 02:38
TRACK 001 TRACK 001
02:38 02:38
TRACK 001 TRACK 001
02:38 02:38
c Select ( ) Jump Page
CD
2.
Press the ▲▼◄► buttons to move
to a desired track, and then press the
yELLOW (C) button. A check appears
on the track.
Repeat this procedure to select
additional tracks.
3.
To remove a track from the list, move to
the track, and then press the yELLOW
(C) button again.
The check on the track is cancelled.
4.
When done, press the v button.
5.
To go to the Music List, press the
RETURN button.
NOTE
✎
` You can create a playlist with up to 99 tracks
on Audio CDs (CD-DA).
16
02273B-BD-E5400-ZC-ENG.indd 16

Playing Photo Contents

You can play photo contents located on a
DVD, CD, or a USB storage device.

Using the Tools menu

During playback, press the TOOLS button.
1/2 Page
Slide Show
Select to start the slide show.
Background
Select to listen to music while
Music
viewing a slide show.
Select to enlarge the current
Zoom
' Return
picture. (Enlarge up to 4 times)
Select to rotate the picture. (This
Rotate
will rotate the picture either
clockwise or counter clockwise.)
Information
Shows the picture information.
NOTE
✎
` Depending on the disc or storage device, the
Tools menu may differ.
` To enable the background music function, the
photo file must be in the same storage media
as the music file.
However, the sound quality can be affected
by the bit rate of the MP3 file, the size of the
photo, and the encoding method.
` You can't enlarge the subtitle and PG graphic
in the full screen mode.

Appendix

Troubleshooting

Before requesting service, please try the following solutions.
PROBLEM
No operation can be • Check the batteries in the remote control. They may need replacing.
performed with the remote
• Operate the remote control at a distance of no more than 20 feet.
control.
• Remove batteries and hold down one or more buttons for several minutes
to drain the microprocessor inside the remote control to reset it. Reinstall
batteries and try to operate the remote control again.
Disc does not play. • Ensure that the disc is installed with the label side facing up.
• Check the region number of the Blu-ray Disc/DVD.
Disc Menu does not appear. • Ensure that the disc has disc menus.
The prohibition message • This message appears when an invalid button is pressed.
appears on the screen.
• The Blu-ray Disc/DVD's software doesn't support the feature (e.g., angles).
• You've requested a title or chapter number or search time that is out of range.
Play mode differs from the • Some of the functions selected in the Setup Menu may not work properly if
Setup Menu selection. the disc is not encoded with the corresponding function.
The screen ratio cannot be • The Screen Ratio is fixed on your Blu-ray Disc/DVD.
changed.
• This is not a problem with the player.
No audio. • Make sure you have selected the correct Digital Output in the Audio Options
Menu.
The screen is blank. • If the HDMI output is set to a resolution your TV cannot support (for example,
1080p), you may not see a picture on your TV.
• Press the @ button (on front panel) for more than 5 seconds with no disc
inside. All settings will revert to the factory settings.
• When the factory default settings are restored, all stored user BD data is
deleted.
SOLUTION
2012-09-06 오후