Installation; General - Ovention Matchbox M1313 Manuel D'installation

English

General

Ovention matchbox Ovens are shipped with most
® ®
components pre-assembled. Care should be taken when
unpacking the shipping carton to avoid damage to the unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE HAzARD: Do not install unit on or around combustible
surfaces. Discoloration or combustion could occur. Unit
must be installed in non-combustible surroundings only.
CAUTION
Locate unit at proper counter height in an area that is
convenient for use. Location should be level to prevent
unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
NOTICE
Do not lay unit on front or back side. Damage to unit could
occur.
NOTE: Due to the size and weight of the Matchbox Oven, use
the proper number of people for installation based on
the weight of the oven.
1. Inspect the shipping container for obvious signs of transit
damage. If damaged, inform the freight company
immediately. CAUTION! Stop! Do not attempt to use
oven if damaged. Contact Ovention for assistance.
2. Cut and remove the shipping bands from around the oven
packaging.
3. Remove tape and protective packaging from all surfaces of
the unit.
4. Remove cooking racks and crumb trays from packaging.
5. Inspect the oven for freight damage such as dents in the
end caps or inside the oven chamber. If damaged, inform
the freight company immediately.
CAUTION
DO NOT lift unit by platforms on each side of oven
chamber. Platforms are not designed to support weight of
unit. Lift from underneath oven chamber only.
6. Place the unit in the desired location. make sure to lift from
underneath the front and rear of the oven chamber only.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70° F
(21° C).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop/table is level and strong
enough to support the weight of the unit and food
product.
• Position the unit with a minimum 1" (25 mm) clearance
at the back and on either side for proper venting.
• make sure all the feet on the bottom of the unit are
positioned securely on the countertop/table.
Form No. OVmm-1013
7. Install a crumb tray underneath each platform.
• Slide the tray underneath the platform and into the tray
support against the oven chamber.
• Position the two hooks on the tray into the holes at the
end of the platform.
Installing a Crumb Tray
8. Install a cooking rack onto each cooking surface of the
slider assembly.
• move the slider assembly manually to install the racks.
Rack
Support
Installing a Cooking Rack
9. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
NOTE: The oven is suitable for either 208 VAC or 240 VAC and
will adjust automatically to the voltage being supplied.
7

INSTALLATION

Right Platform
Crumb Tray
Hook
Tray
Support
Cooking
Rack
Rack
Support