Troubleshooting Guide - AIRHEAD MACH 2 Mode D'emploi

Your AIRHEAD inflatable is equipped with one or more of the following valve types:
Boston Valve
Inflating: Be sure that the Boston Valve is tightly installed by turning the square base
clock-wise. Unscrew the top cap counter-clockwise. Inflate using an AIRHEAD air pump.
Deflating: Remove the entire valve by turning the square base counter-clockwise.
Multi-Valve Adapter
Inflating: Unscrew the cap from the Boston Valve and replace with Multi-Valve. Fill
with standard air chock. Do not over-inflate!
Deflating: Remove the entire valve by turning the square base counter-clockwise.
Speed Valve
Inflating: Pull out the cap and insert the pump fitting into the valve. Be sure to open the
flap at the base of the valve.
Deflating: Deflate using your AIRHEAD pump, or insert a blunt object to open the flap.
Monitoring & Maintaining Proper Inflation:
To prevent serious damage to seams and I-beams, remove some air or move to a shaded
area when exposure to direct sunlight heats up the tube and causes the air inside to expand.
Add some air if exposure to cool air or water lowers the air pressure inside.

TROUBLESHOOTING GUIDE

Product won't hold air: Make sure that the valve is installed properly by removing and
re-installing. If you suspect that the product was not inflated fully, add some air.
Valve is leaking: Make sure that the valve was screwed into the threads correctly. Valve
and cap must be screwed down tightly.
Bladder does not get firm and/or Nylon Cover is loose: Your air pump probably
doesn't produce enough pressure to completely fill the bladder, no 12 volt pump does.
Top off your inflatable with an AIRHEAD Double Action Hand Pump or Foot Pump.
LIMITED WARRANTY
Kwik Tek Inc. Warrants, to the original purchaser only, when their products are used for
normal recreational purposes.
That all Kwik Tek inflatables are free from defects in materials and workmanship for a
period of 90 days from original purchase date. Any implied warranties are also limited in
duration to the 90 day period from the original purchase date.
There are no warranties that extend beyond the description on the face hereof. Kwik Tek
should not be held liable for incidental or consequential damages.
Kwik Tek Inc. shall inspect all warranty claims and in the event of a defect, repair or replace
the defective part or entire item, at its option. A return authorization number (RA#) must be
obtained prior to return by calling or writing to the telephone or address listed in this manual.
Merchandise must be returned, postage prepaid along with proof of purchase to the address
below with the RA# in bold on the outside of the package.
This warranty does NOT cover: FAILURE CAUSED BY OVERINFLATION, TEARS, CUTS,
PUNCTURES OR SNAGS OBTAINED DURING NORMAL USE; ITEMS INVOLVED IN
ACCIDENTS, ITEMS FOR RENTAL OR HIRE AND OTHER USES NOT CONSIDERED
NORMAL RECREATIONAL USES OR IMPROPER STORAGE. FADING from exposure
to sunlight is also not covered by this warranty.
THERE ARE NO WARRANTIES THAT EXTEND BEYOND THE DESCRIPTION ON THIS
CARD. KWIK TEK INC. SHALL NOT BE HELD REPSONSIBLE IN ANY WAY FOR ANY
INCIDENTAL AND/OR CONSEQUENTIAL DAMAGES.
THIS WARRANTY IS IN LEIU OF ALL OTHER WARRANTIES. This warranty gives you
specific legal rights. You may also have other rights that vary from state to state.