Troubleshootin Guide - Sears CRAFTSMAN 919.727110 Mode D'emploi

VOLTAGE SOURCES, MOVING PARTS OR COMPRESSED AIR SOURCES ARE EXPOSED WHEN REPAIR-
ING THE COMPRESSOR. PERSONAL INJURY CAN OCCUR. UNPLUG THE COMPRESSOR BEFORE
ATTEMPTING ANY REPAIRS.
PROBLEM
Air Leaks
Compressor is not deliver-
ing enough air.
Motor will not run.
High discharge pressure.
Cannot be adjusted lower.
All manuals and user guides at all-guides.com

TROUBLESHOOTIN GUIDE

CAUSE
Hose fitting loose.
Prolonged excessive use of air.
Hole in hose.
Air leaks.
Fuse blown, circuit breaker
tripped.
Extension cord is wrong length or
gauge.
Loose electrical connections.
Faulty motor.
Adjustable pressure valve not
functioning.
9 — ENG
CORRECTION
Tighten fitting.
Decrease the amount of air usage. Your
compressor is not large enough for the air
requirement.
Replace the hose.
Tighten fittings.
1. Check fuse box for blown fuse and replace
as necesssary. Reset circuit breaker. Do
not use a fuse or circuit breaker with higher
rating than that specified for your particular
branch circuit.
2. Check for proper fuse. You should be
using a Time Delay fuse.
3. Check for low voltage problem.
4. Check the extension cord.
5. Disconnect the other electrical appliances
from circuit or operate the compressor on
its own branch circuit.
Check the extension cord.
Check wiring connection inside terminal box
Have checked at a local Sears Service Center.
RISK OF BURSTING. DO NOT OPER-
ATE THE COMPRESSOR IF THIS PROB-
LEM EXISTS. ADJUSTABLE PRESSURE
VALVE MUST BE REPLACED.
D24087