Exit MSP-30107-V01 Mode D'emploi page 9

swimming pool cover can dramatically reduce the heating time and preserve the heat
from losing;
Time delay - The heat pump has a built-in 3-minute start-up delay to protect the
circuitry and avoid excessive restarting. The unit will restart automatically after this
time delay expires.
4.5 Condensation
The air suctioned into the heat pump will be cooled to be a very low temperature
by the evaporation process of your heat pump's refrigerant, at its heating mode.
This may cause condensation on fins of the evaporator, which might be as much as
several litters per hour at high relative humidity. Sometimes users may treat this
phenomenon as water leakage, while this is quite normal and no need to do anything.
5.0 Operation of the controller
5.1 Buttons of the controller
When the heat pump is running, the LED display shows the water outlet temperature.
LED 1 is on when compressor is running. LED 2 is on if the keys are locked to avoid
children's mis-operation. When the heat pump is switched off, it displays "OFF" on
the controller LED display. When the heat pump is switched off, it shows "OFF" on the
LED display.
Up or down
5.2 Turn on/off the heat pump
Press ON/OFF for 3 seconds to turn on the heat pump, on the LED display it shows
your setting water temperature for 5s, then show outlet water's temperature. Fan
motor will start to run firstly, after 15 seconds, the compressor starts to run.
Press ON/OFF for 3 seconds again to turn off the heat pump, compressor stops
firstly, after 30 seconds the fan motor stops.
At the first time of power on, the heat pump will run to heat directly if the outgoing
temp.(Tout)≤setting temp.(Tset), without considering the parameter "Temp.
difference for restart activation".
10
MSP-30107-V01