Installation And Connection - Exit MSP-30107-V01 Mode D'emploi

4.0 Installation and connection

ATTENTION: Please pay attention to the following rules when installing the heat
pump:
1). Any addition of chemicals must be carried out at the piping located downstream
from the heat pump.
2). Always hold the heat pump upright. If it has been held at certain angle more than
30°, wait at least 24 hours before starting the heat pump.
4.1 Location of your heat pump
The heat pump will work properly in any desired location as long as the following
three factors are present:
1). Fresh air;
2). Electricity;
3). Swimming pool water
The unit may be installed in virtually any outdoor location as long as the specified
minimum distances to other objects are maintained (see drawing below). Please
consult your installer for installation with an indoor pool. Installation at a windy
location does not present any problem at all, unlike the situation with a gas heater.
ATTENTION: Never install the heat pump in a closed room with limited air volume
in which the air discharged from the heat pump will be reused, or close to shrubbery
that might block the air inlet. Such locations impair the continuous supply of fresh air,
7
MSP-30107-V01