Operating Your Refrigerator - Beko GNE 35715 S Mode D'emploi

of 1 minute until water comes from the
Dispenser. Water flow may be irregular in the
beginning. Irregular water flow will be
normalized after the air in the system is
discharged.
• When the refirigerator is run for the first
time, Water Dispenser choice will be selected
automatically. However, approximately 12
hours must pass before cold water can be
obtained.
• Water mains pressure must be between 1-

Operating your refrigerator

Before you start using the fridge/freezer check
that:
1. The feet have been adjusted so that the
product stands level.
2. The interior is dry and air can circulate
freely at the rear.
3. Clean the interior as recommended under
"CLEANING AND CARE."
4. Plug the refrigerator into the power mains
outlet.
• When the door is open the respective
interior light will come on.
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also give rise
to noise, even if the compressor is not running
or not which is quite normal.
Due to the operation of fans inside the
appliance, overall noise level is slightly
higher in comparison to non-frost free
appliances. This is quite normal and is
not a fault.
6. Front edges of the refrigerator may feel
warm. This is normal. These areas are
designed to be warm to avoid condensation.
7. Do not fill the interiors of the refrigerator
in initial operation. Wait until the correct
storage temperature has been reached. (See
page 16)
8 bars for the operation of Ice/water Dispenser
smoothly. For this, check that 1 glass of water
(100 cc) can be filled in 10 seconds.
• The first 10 glasses of water should not be
consumed.
• 12 hours must pass to obtain ice from the
Ice Dispenser for the first time. In case not
enough ice is present in the ice dispenser,
ice may not be obtained from ice dispenser.
• Approximately the first 30 cubes of ice to be
obtained from the ice dispenser must not be
used.
8. When the compartments reach the
desired temperatures fans will stop.
9. Especially pay special attention to prevent
the foodstuffs, in particular, small pieces,
such as rice, peas and beans from running
into the fan protectors and air flow ducts.
These may cause clogging of the cooling
system and a decrease in the efficiency of
the device.
10. The factory set temperature is +4°C for
fridge compartment and -18°C for freezer
compartment.
11. The compressor will start running
approximately 5 minutes after the refrigerator
is plugged in to protect the electronic
components of your appliance. After startup
o f t h e c o m p r e s s o r , c o m p a r t m e n t
temperatures will reach to the setup
temperatures in 24 hours depending on the
ambient temperature and load status of your
refrigerator.
12. Pay attention to the following points during
the first 24 hours of the operation:
-Do not open the doors frequently.
-Do not overload your refrigerator.
-Do not put hot food.
EN
14