EFBE-SCHOTT TO 2500 Mode D'emploi page 8

Fax +32 2 359 95 50

coming up. Be extremely strict about this as toasters are the cause of many fires when
these elementary safety precautions are not observed.
Empty the appliance frequently of breadcrumbs. Make sure the appliance is always

unplugged before emptying it. Check the « Maintenance and Cleaning » section.
When cleaning the appliance, do not use metallic scourers in order to avoid any future risk

of electric short-circuit.
Your appliance must never be switched on through an external timer or any kind of

separate remote control system.
Competent qualified service: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this service.
OPERATION
 Before using your appliance for the first time, check if it is clean (see "Maintenance and
cleaning") as it comes into direct contact with bread. Check if any object has fallen into
the slot.
 In the first time, connect the appliance only to a mains earthed wall socket. A grommet
on the bottom of the appliance enables to maintain the cord by positioning it to the
backside of the appliance.
 CAUTION: It is normal if some smoke or smell emanates from the appliance when using it
for the first time. Therefore, we advise you to use your appliance empty once before the
first use.
 Place the bread slices in the slot (for French bread, cut a loaf shorter than the slot, then
cut it in two pieces along its length). Your appliance is provided to receive French bread,
but also pieces of toast or other bread slices if their thickness and their length are shorter
than the one of the slot.
 Press down the bread carriage handle until it stops. Then release the pressure and the
handle will stay in the lower position, which means that the heating process has begun. If
the handle comes up immediately, check if the appliance is plugged in as it blocks only
when the unit is plugged in.
 You can adjust the browning intensity to obtain a more or less toasted bread by
positioning the browning control selector to one of the degrees marked from 1 to 7.
Therefore you only have to turn clockwise to increase the intensity, and anticlockwise to
decrease it. The higher the number is, the more toasted the bread will be.
 During the functioning, if you think that the bread is toasted enough or for another reason,
you can break the heating process, simply by pressing the cancel button.
 The reheat button allows you to reheat already toasted bread or to toast bread which is
not toasted enough during a short time without modifying the browning degree.
 The defrost button allows you to toast bread that has been frozen beforehand.
 At the end of the cycle, the bread carriage handle unlocks and you can take the toast
out.
 Always unplug the appliance after use and let it cool down before handling or storing it.
 When storing your appliance, wind the cord around the cord storage facility underneath
the appliance and attach the end of the cord in the notch.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Back cover page
Assembly page 8/18
SC TO 2500 - 140325