Technical Data; Cleaning And Maintenance; Repairs - Cartrend 146000 Notice D'instructions Originale

TECHNICAL DATA

Rated voltage:
idle speed:
weight:
acoustic pressure level:
Vibration:
clockwise/anticlockwise
rotation:
Size of chuck:
max. Torque:
battery block
PLESSEY200ADW:
Charger input:
Charger output:
Charging time:
Measured vales according to EN 62841-2-2 and EN
62841-1.
Warning: The actual vibration value during use
of the machine may vary from that stated in the
instruction manual or by the manufacturer. This may
be caused by the following influencing factors that
should be noted before and during every use:
- Is the machine being used correctly
- If the type of material to be processed is correct
- Is the machine's condition in use OK
- Are the handles or optional anti-vibration handles
mounted and are they firmly fixed to the body of
the machine.
- If you have an unpleasant feeling or a discoloura-
tion of your skin on your hands while using the
machine interrupt your work immediately. Take
sufficient breaks form your work. Not observ-
ing sufficient breaks from your work can lead to
hand-arm-vibration syndrome. An assessment
should be made of the degree of stress resulting
from the work and use of the machine and breaks
from work taken accordingly. This can significantly
reduce the degree of stress over the entire work-
ing time. Keep the risks to which you are exposed
through vibrations to a minimum. Care for this ma-
chine in accordance with the instruction manual.
If the machine is employed/used in a regular basis,
you should contact your specialist dealer and pur-
chase anti-vibration accessories (handles).
Avoid using the machine at temperatures of t=10°C
or below. Prepare a work schedule that allows
146000_Schlagschrauber_BAL_191210.indd 25 146000_Schlagschrauber_BAL_191210.indd 25
All manuals and user guides at all-guides.com
12 V d.c.
n : 0 - 5500/min
0
1,4kg
L : 85 dB (A) ; K : 3dB(A)
PA PA
L : 96 dB (A) ; K : 3dB(A)
WA WA
a = 7,58 m/s ; k=1.5 m/s
2 2
h
yes
10mm
300Nm
12 V DC, 2000 mAh
(Li-ion)
100-240V AC
50-60Hz 30W
12.6V DC 1500mA
80 minutes
vibration stress to be limited.
Warning: Some noise pollution from this device
is unavoidable. Schedule noise-intensive work to
authorised and designated times. Where required,
keep to rest periods and limit the working time to
the necessary minimum. For your personal protec-
tion and the protection of persons in the vicinity,
suitable hearing protection must be worn.

CLEANING AND MAINTENANCE

Switch off the on/off switch and remove the battery
before performing any cleaning work.
Cleaning
Keep protective devices, ventilation slits and motor
housing as clear of dust and dirt as possible. Wipe
of the device with a clean cloth or use low-pressure
compressed air to blow off the dust and dirt. We
recommend cleaning the device immediately after
each use. Clean the device on a regular basis with
a damp cloth and a little neutral soap. Do not use
any detergents or solvents as these may corrode the
plastic pasts of the device. Make sue that no water
can penetrate the inside of the device.
Maintenance
There are no parts inside the device requiring
maintenance.

REPAIRS

Only use accessories and replacement parts recom-
mended by the manufacturer. Should the device
malfunction – despite our quality controls and your
care – have repairs performed exclusively by an
authorised, qualified electrician.
25
16.12.19 17:03 16.12.19 17:03