Intended Use; Improper Use; Residual Risks; General Safety Notices - Cartrend 146000 Notice D'instructions Originale

Warning!
Several safety measures must be observed when
using equipment in order to avoid injury or damage.
Consequently, please carefully read this instruction
manual / these safety notices. Keep them in a safe
place to enable you to access the information at all
times. Should you pass on the device to another
person, please hand over this
instruction manual / these safety notices
along with it. We will not accept any liability for any
accidents or damage caused by non-observation of
these instructions or the safety notices.

INTENDED USE

This tool is suitable for loosening or tightening nuts
and bolts. Using the tool for other kinds of work is
dangerous and absolutely must be avoided. While
the tool is in use the tool user must ensure that
adequate protective equipment is worn/is in place
in accordance with the instruction manual and the
warning pictographs on the machine. Prior to every
use and during use of the device, the device and the
screwdriver bit must be checked for any functional
or mechanical damage. Should any damage to the
tool be identified, cease all work with it immediately
and contact a specialist workshop.

IMPROPER USE

Any application of the device other than those
stated in the chapter "Intended use" will be deemed
improper use. The device may not be used for the
following purposes:
- Polishing, grinding, sharpening, engraving with the
appropriate intentions
- Any use that is not listed as an intended use
- Use as a mounted device
- Use as a drive for other devices
There is a risk of injury. The user of the device will be
liable for all damage to property and personal injury
resulting from misuse.
Use of other or non-OEM components on the
machine will void the manufacturer's warranty.
18
146000_Schlagschrauber_BAL_191210.indd 18 146000_Schlagschrauber_BAL_191210.indd 18
All manuals and user guides at all-guides.com

RESIDUAL RISKS

Even when using the tool correctly there is always
a certain amount of residual risk that cannot be
excluded. The following potential hazards can be
derived from the nature and design of the tool:
- Contact with the rotating drill chuck (crush injury)
- Reaching into the rotating device (cutting injury)
- Damage to hearing if no prescribed hearing
protection is worn
- Inhalation of drill particles
- Electric shock when touching non-insulated electrical
components
If the instructions contained in the instructions for
use are not observed, other residual risks may arise
on account of incorrect usage.
I. GENERAL SAFETY NOTICES
WARNING
Failure to observe the safety instructions and
directions may cause electric shocks, fires and/or
serious injury!
Store all safety instructions and guidelines for
the future.
General safety instructions for power
tools
The term "power tool" used in the safety instruc-
tions refers to mains-operated power tools (with
power cord) or battery-powered power tools (with-
out power cord).
1) Safety in the workplace
a) Keep your workplace clean and well lit. Untidy
or unlit work areas may lead to accidents.
Read all safety instructions, guide-
lines, images and technical data
provided with this power tool.
16.12.19 17:03 16.12.19 17:03