Velleman CAMCOLVC18 Mode D'emploi page 11

8. While you press and hold the menu button on the camera, plug the
camera in a free USB port on your computer.
9. Release the menu button only when you hear a beep and the camera
display lights. The camera display shows "PC".
Windows® automatically recognises the device and installs the driver.
Depending on the settings, Windows may (not) display the message
"Your new hardware is installed and ready for use".
The camera is now ready for use as a webcam.
8. Troubleshooting
There is nothing on the display
Make sure the batteries are installed correctly.
Replace empty batteries.
The camera shuts off automatically
The batteries are empty. Replace them immediately.
I cannot record video
Make sure there is sufficient free space on the memory card. The display
indicates how much time there is left for recording.
Make sure the memory card is not locked. Make sure the lock switch on the
side of the memory card is in the correct position.
The camera stops recording automatically
The memory card is full.
• Back up the files on the card to your pc, then delete files on the card to
create free space.
• Insert a new, empty card.
I connected the camera to my pc, but I cannot find it in My
Computer
Make sure that each end of the USB cable is properly connected.
Make sure the USB port on the pc is working properly. Try connecting
another USB device and see if it functions well. If no, the USB port may be
malfunctioning.
The video does not play on my TV
Make sure that each end of the video cable is properly connected.
Make sure that the camera is switched on.
The remaining recording time is not accurate
The remaining recording time is an estimate. It depends not only on the
time already recorded, but also on the conditions in which you have
recorded. Recording in high-contrast conditions, such as outdoors, requires
more memory space than recording in low-contrast conditions, such as
indoors.
V. 02 – 02/10/2012
CAMCOLVC18
11 ©Velleman nv