Panasonic CZ-RWSU2N Instructions D'installation page 9

Wiring Diagram
Terminals for RC
wiring
How to Connect the Wires
Connect the wires from the receiver to the terminals for RC
1 While spreading the tabs of the cover, pull it out from the panel to the front. (Fig. A)
2 When installing on the 1-WAY cassette (high-ceiling), pass the lead wire through the panel and
install the receiver in the hole in the panel. (The projecting parts of the receiver are fixed in the
hole in the panel.)
3 Route the lead wire from the receiver along the rib on the back of the panel. Pass it through the
cutout. (Fig. B)
4 Install the panel on the indoor unit.
5 Fasten the lead wire sticking out from the panel with the clamper in the indoor unit. (Fig. C)
6 Draw the lead wire into the electrical box through the hole on the bottom and connect it to the
remote controller terminal board.
When installing to the 1-WAY cassette (high-ceiling), fasten the wire at the latch of the fan
casing with the supplied clamper. (Fig. D)
Fig. A
Pull out
from the
panel.
Fig. C
1-WAY cassette
(high ceiling)
 Fasten the lead wire securely so that it does not get wrapped up in the fan.
 For more information about wiring and test operation, see the sections on "Wiring for the Receiver" and
"Test Operation" .
3-4. Wiring for the Receiver
Indoor unit
1
2
3-5. Installing the Receiver
Fig. B
Spread
Cover
Insert
the lead
wire.
Spread
Fig. D
1-WAY cassette
Clamper
Receiver PCB
CN001
2P white
on the indoor unit. (No polarity)
wiring
1-WAY cassette
(high ceiling)
( Back
of the
panel)
Receiver
Rib
Insert
the lead
wire.
Cutout
Fan casing
CZ-RWSD2
1-WAY cassette
Receiver
Rib
Fasten the wire
at the latch of
the fan casing
with supplied
clamper.
9