Using The Control Panel - Dell 1200MP Manuel Du Propriétaire

Using the Control Panel

4
3
2
1
1 Power
2 Source
3 Four Directional
Keys
4 TEMP warning light
5 LAMP warning light
6 Keystone adjustment If your image is not perpendicular to the screen, then it
7 Resync
16
Using Your Projector
Turn the projector on and off. For more information,
see "Turning Your Projector On" on page 11 and
"Turning Your Projector Off" on page 11.
Press to toggle through Analog RGB, Composite,
Component-i, S-video, and Analog YPbPr sources when
multiple sources are connected to the projector.
The four directional keys
toggle through the tabs in the OSD.
• A solid orange TEMP light indicates that the projector
has overheated. The display automatically shuts
down. Turn the display on again after the projector
cools down. If the problem persists, contact Dell.
• A blinking orange Temp light indicates that a
projector fan has failed and the projector
automatically shuts down. If this problem persists,
contact Dell.
If the Lamp light is solid orange, replace the lamp.
does not appear square. Press to adjust image distortion
caused by tilting the projector. (±16 degrees)
Press to synchronize the projector to the input source.
Resync does not operate if the on-screen display (OSD)
is displayed.
5
6
7
8
can be used to