Operating Procedures - Sears CRAFTSMAN 919.727340 Manuel

OPERATING PROCEDURES

1. Before attaching air hose or accessories, make sure
the "AUTO/O" lever is set to "O" and the air
regulator is closed.
2. Attach hose and accessories.
TOO MUCH AIR PRESSURE CREATES
A HAZARDOUS RISK OF BURSTING.
CARE-FULLY FOLLOW STEPS 3 AND 5
BELOW EACH TIME
SOR IS USED.
Compressed air from the outfit may contain
water condensation. Do not spray unfiltered
air at an item that could be damaged. Some
air operated tools or devices may require
filtered air. Read the instructions for the air
tool or device.
3. Check the manufacturer's maximum pressure rating
for air tools and accessories. The regulator outlet
pressure must never exceed the maximum pressure
rating.
4. Turn the "AUTO/O" lever to "AUTO" and allow tank
pressure to build. Motor will stop when tank
pressure reaches "cut-out" pressure.
5. Open the regulator by turning it clockwise. Adjust
the regulator to the correct pressure setting. Your
compressor is ready for use.
All manuals and user guides at all-guides.com
THE COMPRES-
6. Always operate the air compressor in well-ventilated
areas; free of gasoline or other solvent vapors. Do
not operate the compressor near the spray area.
WHEN YOU ARE FINISHED:
7. Set the "AUTO/O" lever to "O".
8. Turn the regulator counterclockwise and set the
outlet pressure to zero.
9. Remove the air tool or accessory.
10.Open the regulator and allow the air to slowly bleed
from the tank. Close the regulator when tank
pressure is approximately 20 psi.
11.Drain water from air tank.
WATER WILL CONDENSE IN THE AIR
TANK. IF NOT DRAINED, WATER WILL
CORRODE AND
TANK CAUSING A RISK OF AIR TANK
R U P T U R E .
If drain cock valve is plugged, release all air
pressure. The valve can then be removed,
cleaned, then reinstalled.
12. After the water has been drained, close the drain
valve. The air compressor can now be stored.
9
WEAKEN THE AIR
NOTE: