Pioneer PDR-F10 Mode D'emploi page 19

Tip
If you want to record a copy-protected CD, you
can switch select analog recording over the
default digital. Between steps 3 and 4 above,
select the analog input:
• Press INPUT SEL. (top panel only)
to set the input.
Pressing
INPUT SEL
active input:
Automatically recording
from a tape
This feature, like automatically recording
from a CD, will start and stop the tape player
and the CD recorder together.
CD
4 ¢
7
SYSTEM
DISP
CHARACTER
1 Load a CD–R or CD–RW disc.
If it's a blank disc, the display indicates this.
If the disc isn't blank, use the
check that there's enough space on it for what
you want to record.
All manuals and user guides at all-guides.com
. repeatedly switches the
button to
DISP
4 Getting Started
2 Press TAPE to switch to the tape
player.
3 Load the tape you want to record.
Select the appropriate tape player options
(auto reverse, Dolby B NR). See the operating
instructions included with the tape player for
more on this.
Press 7 to make sure that the tape is stopped.
4 Press REC (top panel only).
The CD recorder goes into record-pause,
waiting for you to start the tape player, and
the indicator lights.
SYNC
5 Press TAPE to start the tape
playing.
Recording starts automatically with the tape.
Once the tape has finished playing, the CD
recorder goes back into record-pause.
• If you want to stop recording before the
end of the tape, press 7.
• If you run out of space on the CD before
the tape is finished, the CD recorder goes
back into record-pause.
If you're done, press 7.
6
After pressing 7, the recorder writes the track
information to the disc.
Take out the disc before switching the recorder
off.
• Manufactured under license from
Dolby Laboratories.
• "Dolby" and the double-D symbol are
trademarks of Dolby Laboratories.
G001 En
19
En