For Your Safety; Machine-Specific Safety Warnings - Wurth Master STP 28-A Notice D'utilisation

All manuals and user guides at all-guides.com
STP 28-A.book Seite 12 Dienstag, 13. Mai 2008 9:56 09
GB
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result in electric
shock, fire and/or serious injury. Save all safety
warnings and instructions for future reference.
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed. In addition, the general safety instruc-
tions in the enclosed booklet must be followed.
The machine may not be damp and
may also not be operated in damp
surroundings.
Wear safety goggles.
For long hair, wear hair protection.
Work only with closely fitting
clothes.
Wear protective goggles, ear pro-
tection.
For mounting and replacing of the
saw blade, wear protective gloves.

Machine-specific Safety Warnings

When working, never guide a hand or fingers in
front of the saw blade.
Do not work with materials containing asbestos.
Apply the machine to the workpiece only when
switched on.
The cutting path must be free of obstacles both
above and below.
When sawing, the complete surface of the base
plate 10 should securely rest on the material. For
the working of smaller or thin workpieces, use a
stable foundation or a saw table (accessory).
When the cut is completed, switch off the machine
and then pull the saw blade out of the cut only after
it has come to a standstill (danger of kick-back).
Do not brake the saw blade to a stop by applying
side pressure after switching off.
Use only sharp, flawless saw blades. Change
cracked, bent or dull saw blades immediately.
12

For Your Safety

Never allow children to use the machine.
Always remove battery before working on ma-
chine.
Chips or splinters may not be removed while
the motor is running.
Plunge cutting is only possible in soft materials
(wood, light building materials for walls); for
hard materials (metals), a hole must be drilled
that is sufficiently sized to accommodate the
saw blade.
When the battery is inserted while the On/off
switch is pressed, the machine will not restart
again for safety reasons!
Hold the power tool by the insulated gripping
surfaces when performing operations where
the application tool could contact hidden
wires. Contact with a "live" wire will also make
exposed metal parts of the power tool "live"
and shock the operator.
When working with the machine, always hold
it firmly with both hands and provide for a se-
cure stance. The power tool is guided more se-
cure with both hands.
Secure the workpiece. workpiece clamped with
clamping devices or in a vice is held more se-
cure than by hand.
Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over
the power tool.
Avoid unintentional switching on. Ensure the
On/Off switch is in the off position before in-
serting battery pack. Carrying the power tool
with your finger on the On/Off switch or insert-
ing the battery pack into power tools that have
the switch on invites accidents.
Before each use, check the machine and battery.
If damage is detected, do not use the machine.
Have repairs performed only by a qualified tech-
nician. Never open the machine yourself.
Before any work on the power tool (e. g.
maintenance, changing the tool, etc.), remove
the battery. There is danger of injury from an
accidentally starting power tool.
Use power tools only with specifically desig-
nated battery packs. Use of any other battery
packs may create a risk of injury and fire.
Never allow children to use the machine.
Use only original Würth parts and accesso-
ries.