GE JCK1000 Installation page 36

Electrical Connections
B
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction box. A
plug and receptacle is NOT permitted on these
products.
DO NOT
The conduit strain relief clamp must be securely
conduit must be securely attached to the
the clamp, do not install the oven until a clamp
of the proper size is obtained.
NOTE TO ELECTRICIAN: The 3 power leads
supplied with this appliance are CSA
recognized for connection to heavier gauge
household wiring. The insulation of these 3
leads is rated at temperatures much higher
than the temperature rating of household
wiring. The current carrying capacity of the
conductor is governed by the wire gauge
and the temperature rating of the insulation
around the wire.
WARNING:
connection of aluminum house
wiring to copper leads can result
connectors designed for joining copper to
aluminum and follow the manufacturer's
recommended procedure closely.
Installation Instructions
Improper
B1
B2
Conduit
Place oven on a
support to assist in
connecting conduit
B3
3 insulated conductors (copper)
1 bare ground conductor (copper)
B4
8
Junction Box
Location
BARE
GROUND
RED
WHITE
Strain Relief Clamp
(not included) must be
used at Junction Box
GROUND
WIRE