Kenmore 6012 Guide D'utilisation Et D'entretien page 12

First try the solutions suggested here for assistance and to possibly avoid a service call.
If you experience
Cycle time too short
Automatic cycle ending early.
Lint on load Lint screen clogged.
Stains on load or drum Dryer fabric softener not properly used.
Loads are wrinkled The load was not removed from dryer at
the end of the cycle.
Dryer tightly packed.
You have recently been painting, staining,
Odors
or varnishing in the area where your dryer
is located.
The electric dryer is being used for the first
time.
Load is too hot Laundry items were removed from the
dryer before the end of the cycle.
A high temperature cycle was used or the
Dry Temp was set on high.
12
TROUBLESHOOTING
Possible Causes
The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the dry level
setting on Auto Dry cycles.
Increasing or decreasing the dry level setting will change the
amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can
stain your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
function tumbles the load without heat
The Wrinkle Guard ™
for 40 minutes at the end of the cycle to avoid wrinkling.
Dry smaller loads that can tumble freely to reduce wrinkling.
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Allow Cool Down to finish before removing laundry from dryer.
All cycles are cooled slowly to reduced wrinkling and make it
easier to handle. Items removed before Cool Down may feel
very warm.
Select a lower temperature, and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
Solution