Cutting The Opening; Cutout Dimensions - Dometic R31 Série Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

RANGE AND SLIDE-IN

4.2 Cutting The Opening

• Verify the cutout location and dimensions. Refer to "Cutout Dimensions" on page 6.
• Cut the hole for the range or slide-in. The cutout is open; no front edge remains on the counter.
• Confirm a propane-certified gas line is in place that meets the appropriate RV and gas codes.

Cutout Dimensions

I
If using a recessed bi-fold cover, follow the instructions included with the cover for cutout
dimensions, installation, and use.
FIG. 1
E
A
D
B
Range with Oven
17" Ranges
21" Ranges
Slide‑in
* The minimum clearance to combustible materials allowed from the surface of the range or slide‑in to a combustible object (curtains, board,
wall, floor, etc.). Consider both sides, the back side, and above the cabinet when determining clearances. These measurements do not
apply to a side‑by side installation. The range or slide‑in is not intended for side‑by side installations with another range or slide‑in.
I
The maximum depth of cabinets installed above the range or slide-in is 13 in (33 cm). Do not install
any structure directly above the stove (for the width of the stove) except a range hood.
EN
G
F
C
A
B
17.75"
20.25"
(45 cm)
(51 cm)
(3 cm)
17.75"
20.25"
(45 cm)
(51 cm)
(3 cm)
17.75"
20.25"
(45 cm)
(51 cm)
(3 cm)
FIG. 2
D
Slide-In
C*
D
1.13"
16"
1.75"
(41 cm)
(4 cm)
1.13"
20"
1.75"
(41 cm)
(4 cm)
1.13"
3.125"
1.75"
(41 cm)
(4 cm)
E
G
A
F
C
B
E
F
G*
1.5
19.5"
(4 cm)
(50 cm)
1.5"
19.5"
(4 cm)
(50 cm)
1.5"
19.5"
(4 cm)
(50 cm)
6

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

S31 série

Table des Matières