Panasonic VIERA TC-P58VT25 Guide Rapide page 33

Before using a Network camera, you need to register the camera as shown below. You can also
set default camera or disconnect/delete the registered cameras.
■
Press to exit from
a menu screen
■
Press to return
to the previous
screen
All manuals and user guides at all-guides.com
Network camera setting
Follow direction
Select "Setup" and "Network cameras list"
Menu
Network settings
Connection test
Wireless (WiFi)
Network connection
Wireless network
IP address/DNS settings
VIERA CAST setting
Network cameras list
Software update
Mac address 00-0b-97-7c-65-e9
Displays compatible network cameras that
have been connected and registered.
If there is no registered camera
Select "Yes" to start search
Please refer to camera's settings and enable its link
mode.
Start searching for network camera?
Yes No
Set Network camera setting
Network cameras list
Camera name Model Status
Camera 1 BL-C210A Connected
... ...
...
... ...
...
... ...
...
... ...
...
... ...
...
... ...
...
... ...
...
Select OK
RETURN
R Find cameras G Delete
B Disconnect Y Default camera
Network camera setting operation
"Please refer to camera's settings and enable its link mode. Start searching for network camera?"
"Yes" to start camera search.
Before you start to search for a camera, switch the camera to registration
mode. (For this operation, please refer to the operating manual for the
Network camera.)
Search condition also depends on "Network settings" (p.46-49).
"Remove camera information?"
"Yes" to delete camera information.
"Disconnect to camera?"
"Yes" to delete camera connection.
"Disconnected" will be displayed in "Status".
"Set this camera as default camera?"
"Yes" to set to the default use.
Displayed "(Default)" next to camera name.
(Available only when reconnecting)
"Connect to Camera?
"Yes": "Connect" will be displayed in "Status".
(Attach up to 8 Network cameras simultaneously).
- in "Network settings" (p.46)
select
-
next
select
next
select
Default
33