Honeywell CS10XE Mode D'emploi page 3

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
TIMER
Press the TIMER button until the desired time duration setting is selected. When the set time has
passed, the unit will automatically turn off (unit remains in Standby mode until power cord is unplugged
from electrical socket). The TIMER function allows you to program the unit for up to 7.5 hours of use.
SWING
Press the SWING button until
The louvers will begin to move left to right automatically.
Vertical Air Flow - You can manually adjust the louvers to change vertical air flow.
COOL
Press the COOL button until
The water pump will operate and you will feel the cooler air after the Honeycomb Cooling Media is
completely wet.
WARNING: Please ensure sufficient water is in the water tank otherwise you may hear a Low Water
Alarm and the cooler will start in a Fan only mode without evaporative cooling.
REMOTE CONTROL
Note:
The remote control requires a CR2032 (1 x 3V) coin type or equivalent battery for replacement.
Open the battery compartment at the back of the remote control and insert the battery inside. Care
must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside
the battery compartment.
Always point the remote control signal transmitter towards the unit when operating. Make sure that
the signal path is not obstructed.
Remove the batteries if the unit is not going to be used for an extended period of time.
Do not drop the remote control.
Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
Do not mix old and new batteries.
Do not recharge the battery.
Exhausted batteries are to be removed from the product and safely disposed of as per local
regulations.
Do not dispose of batteries in fire. Batteries may explode or leak.
WARNING: Caution for ingestion of the small battery. Keep away from children and animals.
is illuminated on the display screen.
is illuminated on the display screen. This activates evaporative cooling.
Power : ON / OFF
Speed : Low / Medium / High / Sleep*
Cool : Evaporative cooling ON / OFF
Swing : Controls the motion of the louvers
Timer : Controls the Timer function for automatic off
EN
*Applicable for models with Sleep feature only.
2
LOUVER
MOVEMENT